The last line in your access-list 100 is going to activate the dialer for any traffic not explicitly denied in the previous statements. That's probably where your problem lies. If the connection is used just for internet access remove the
access-list 100 permit ip 220.127.116.11 0.0.0.255 any
access-list 100 permit tcp 192.168.0.0 255.255.255.0 any eq 443
access-list 100 permit tcp 192.168.0.0 255.255.255.0 any eq ftp
access-list 100 permit tcp 192.168.0.0 255.255.255.0 any eq (any other ports you really need)
This should eliminate your unwanted dialer activations. You can of course modify the access list to your particular needs.
I noticed something else that may be causing a little confusion as well. Your using the same access-list 100 as both the nat source and dialer list. Use another list for your NAT. acccess-list 1 would work well for this.
ip nat inside source list 1 interface BRI0 overload
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...