Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

801 and QOS

hi all

i've got a cisco 801 version 12.1.3 XG6, i can configure class-map, policy-map

then i can apply service-policy on eth interface but i can't apply service-policy on my BRI or Dialer interface. The router accept it but i don't see it in a sh run or sh policy-map interface.

Is this possible on BRI or Dialer,do i need a specific IOS, do i need another cmde to validate a qos policy on a BRI?

Thanks

1 REPLY
Community Member

Re: 801 and QOS

If you were able to enter the command, but when you looked at the sh run it wasn't there... sounds like it could be a software bug. You should be able to run QOS on a BRI/dialer interface with that IOS.

127
Views
0
Helpful
1
Replies
CreatePlease to create content