One of my clients have a 5 nod network where we up to recently used Cisco 1603 without any problems. Since this model is not possible to buy in Sweden anymore we started using the 801 model with the IP Plus package.
The problem is that on one of the remote offices the router stops accepting inbound calls. Outgoing calls are no problem. There are 3 dialers configured on the router, Dialer0 is used for dial-in support, Dialer1 is used for creditcard transactions, Dialer2 is used for connection to the main office.
Almost every morning we have to reboot the router since the main office cant connect (SQL replication). After the reboot it works fine. If i try to dial in directly over dialer0 before reboot i get that the username is not valid. After the reboot it works fine. When i debug the router in the main office i get the following output:
1d00h: BR0:1 PPP: Treating connection as a callout
1d00h: BR0:1 PPP: Phase is ESTABLISHING, Active Open
1d00h: BR0:1 LCP: O CONFREQ [Closed] id 102 len 15
Do we have any one at the remote office to capture outputs before the router is rebooted? We need to see outputs of : deb isdn q931 / deb ppp nego / deb isdn error.......sh isdn status (should be fine since we connect on isdn layer & fail on layer2, PPP).
Also before reloading the 801(which is failing), try doing a shut/no shut on the BRI...see if that works.
Just curious, is it possible to put in a c1600 & see if it works? I did a bug search & do get an exact match.
What IOS image do you have on the c801? Did you try upgrading the same? Without debug outputs it's difficult to say where the problem lies.
We tried doing a shut/no shut on the BRI but it didnt help. We did at debug and the results are listed at the end. I dont have any C1600 to try with and this model is not possible to buy anymore in Sweden.
IOS running (IOS (tm) C800 Software (C800-SY6-MW), Version 12.0(7)T, RELEASE SOFTWARE (fc2)). I tried reloading the image and i even tried with a new C800.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.