I've an 801 Router and am dialing up on demand. Everything works fine on 1 channel at 64k. As soon as the 2nd channel comes up the router stops routing traffic. The isp suggests that the router should be set to dial up both channels at exactly the same time rasther than 1 and then the other when needed. Does anyone know how to do this? I've tried the bandwidth 128 command in the ios unnder the bri interface and also the dialer interface but still does not work.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.