03-16-2006 05:06 AM - edited 03-03-2019 02:18 AM
The following configuration is possible?. DLSW between a 802.1q subinterface and an Ethernet interface.
Thanks
interface FastEthernet0/0.1
encapsulation dot1Q 300
ip address x.x.x.x x.x.x.x
no ip redirects
ip nat outside
bridge-group 1
dlsw local-peer peer-id x.x.x.x cost 1 promiscuous
dlsw icannotreach sap F1
dlsw bridge-group 1
dlsw udp-disable
bridge 1 protocol ieee
03-16-2006 05:22 AM
What IOS are you running? It should work in newer IOS. Support for this was added through the following bug
http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCdv26715
03-16-2006 05:24 AM
IOS (tm) 3600 Software (C3640-JK8S-M), Version 12.2(15)T17, RELEASE SOFTWARE (fc1)
03-16-2006 05:50 AM
Your IOS should support it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: