802.1Q support on 2610XM Router

[andrew.butterworth]

What is the minimum IOS release & feature set that supports sub-interfaces and 802.1Q trunking. I have looked but probably can't see the wood for the trees........ I need to do interVLAN routing with a 2610XM Router using its FastEthernet interface connected to a Catalyst 2950. I seem to remember that 802.1Q needed IP Plus as a minimum, is this still the case?

Thanks

[donewald]

12.1.1 is the minimum. IP Plus feature set is also required. If you like you can use the feature navigator to see this.

http://www.cisco.com/cgi-bin/Support/FeatureNav/FN.pl

Hope this helps you,

Don

[Prashanth Krishnappa]

The following page should help

http://www.cisco.com/warp/public/473/50.shtml#Table2

[andrew.butterworth]

Shortcuts saved. Thank you kind sirs ;o)

Now why isn't CCO that easy....................