802.1q trunking over ethernet

[sdurmaz]

I have 2610 series router(has only e0/0) and WS-C3550-48 switch.I need two vlan on ethernet segment and to reach them from wan.is it possible 802.1q trunking(not isl) between router(e0/0) and switch(fa0/48)?

Thanks

[Prashanth Krishnappa]

A previous post on similar question should help

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.ee8efdc/2#selected_message

[efrahim]

yes

Here is the example.. Also if you want you can make the connection to the 3550 switch as the layer 3 - routed link and then run routing protocol to take care of the routing between the switch and the router -

http://www.cisco.com/warp/customer/473/50.shtml

or configure them as the routed ports

http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12112cea/3550scg/swiprout.htm