802.1x with VLAN assignment on Catalyst 2950T-48-SI
I will really appreciate if you can confirm me if the C2950T-48-SI will support the following features.
- IEEE 802.1x with VLAN assignment
The data sheet for the Cisco Catalyst 2950 Series Switches with Standard Image mentions all the above and more features for the 2950T-48-SI, but at the same time the power point presentation, (Cisco Catalyst 2950 Series Switches, and the tool Sofware advisor say that those features are only supported with the Enhanced Image.
If your those feature are supported by the Standard Image, would you please also inform the last IOS version supported.
Re: 802.1x with VLAN assignment on Catalyst 2950T-48-SI
SSH isn't available on the SI version of the 2950 as you require the Crypto features and these are not available for the SI (the documentation is a little vague here but trust me I have upgraded one and it doesn't like it...). The documentation says 'Switches that support only the SI cannot run the cryptographic image.'
802.1x with VLAN assignment is available only in the latest IOS - or at least since 12.1(22).
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...