Hi I have an annoyance on my 806 router. When I reboot, my Dial1 interface seems to take 20 to 40 seconds to come up. I do a "debug dial" and I get : Di1 DDR: Cannot place call, no dialer string set. After about 40 seconds my d1 interface finally comes up and I don't get that error anymore. This is not really a problem, but it is an annoyance for me. Can anyone tell me what is wrong? Below is my config...(Edited for privacy, of course!)
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...