06-10-2003 08:24 AM - edited 03-02-2019 08:01 AM
what is the best config for the 806 into a PBX is there protocol that it will can be use to for DSL through it
06-10-2003 09:03 AM
I am not sure how you will be abloe to connect 806 with PBX.. It all depends on what can pbx offer to connect with 806.
You can connect exhisting dsl modem to 806. Also it has 4 port eth hub so that you can connect accordingly.
Visit following link for more on that
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/806/806hwins/install.htm#xtocid11
What exactly you want to achive by connecting it with PBX?
06-12-2003 09:36 AM
Hi here the situtation Client has a Merlin Legend PBX. Went out and got a seperate T1 DSL they were suppose to remain seperate but either someone came and reconfigured the PBX or change the setup and all traffic is running through the T1 not a bad thing except the Internet access was the T1 now access is down to alittle better then 56kb. The router is connected to the PBX by the 25pin connector what I'm looking for is which protocols can I change to so if there is something faster it can get better through put
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide