Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

806 Broadband router to PBX

what is the best config for the 806 into a PBX is there protocol that it will can be use to for DSL through it

2 REPLIES
Cisco Employee

Re: 806 Broadband router to PBX

I am not sure how you will be abloe to connect 806 with PBX.. It all depends on what can pbx offer to connect with 806.

You can connect exhisting dsl modem to 806. Also it has 4 port eth hub so that you can connect accordingly.

Visit following link for more on that

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/806/806hwins/install.htm#xtocid11

What exactly you want to achive by connecting it with PBX?

Anonymous
N/A

Re: 806 Broadband router to PBX

Hi here the situtation Client has a Merlin Legend PBX. Went out and got a seperate T1 DSL they were suppose to remain seperate but either someone came and reconfigured the PBX or change the setup and all traffic is running through the T1 not a bad thing except the Internet access was the T1 now access is down to alittle better then 56kb. The router is connected to the PBX by the 25pin connector what I'm looking for is which protocols can I change to so if there is something faster it can get better through put

85
Views
0
Helpful
2
Replies
CreatePlease login to create content