Setting up a Cisco 806 using CRWS Web Setup software & IOS 12.2.8 - YJ1.
Trying to connect to Comcast cable but 806 getting error that the ISP does not supply DHCP. I currently have a dlink 704 broadband router which connects without any problems so I don't believe it to be a comcast problem.
When I got the router Cisco informed me that if I wanted to use Easy VPN I needed to use IOS 12.2.8 - YJ1.
Could the IOS be causing the problem. Anyone else having this same problem?
Pl. make sure that the 806 is configured like that. You can change the ip's for the ethernet interface connected to internal network....
It does have troubleshooting section too..In order to debug your problem we need to use "debug dhcp detail" command to display DHCP debugging information that can be used to troubleshoot why the Cisco router failed to obtain an IP address for it's ethernet interface..
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...