806 router duplex mode

kactus · ‎10-21-2003

I connected a Cisco Catalyst 2950 switch in fourth interface of my router 806. On the switch, auto-detection sets the ports 10Mbps/Half Duplex.

Does the 806 router supports 10Mbps/Full duplex ?

Thanks

rmcarthur · ‎10-22-2003

No, it has only a 4 port 10base-T hub.

lunestadr · ‎10-23-2003

What about the wan eth. interface on 806, it has the duplex commands, but when I try to set it, it does not show in config. Is it also locked to 10/half ?

regards rolf

rmcarthur · ‎10-24-2003

Hi Rolf, no it seems that the wan port is also only 10baseT.

Regards