Just installed an 837 adsl router at a customer site. Previous they were using a cheapo dsl modem provided by the dsl provider, they were getting 1.5MB down and 512k up. After putting in the Cisco 837 I'm only getting 800k down and 128k upk, what am I missing here?
Thanks for the suggestion. Turns out that the telco had "adjusted" speeds for many of their customers while I was installing this router. Basically they screwed up and reduced the customer's speeds, nice timing, eh?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...