Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

8586 collision

hi

this is a partial out from the sjow interface f0/1.

8586 collision;3 interface reset

;76485 deferred

what this out mean,if error exist how cab i fix it

10xs for help.

ali

B/W. this int is connected to a wirless unites.and this wireless units has connected to the main office

4 REPLIES

Re: 8586 collision

Hi Ali,

This out means output. As this is just a partial output from "sh interface" command.

Anyways there are lot of collisions seen which can be due to speed and duplex mismatch. Can you paste the output of "sh interface fa0/1" and also "sh run intarface fa0/1".

Also if speed and duplex settings are ok then it could be a cable problem also.

Regards,

Ankur

New Member

Re: 8586 collision

HI FRIEND!

ANKUR;SORRY THERE IS TYPING ERROR IN THAT POST

SORRY FRIEND

ALI

New Member

Re: 8586 collision

HI

DID U MEAN CABLING ERROR FROM THE TRANCIVER TO THE SWITCH.OR FROM THE UNITS TO THE TRANCEIVER?

ALI

Re: 8586 collision

Hi Ali,

First check the speed and duplex settings and if that is ok then check the cabling from the switch to where ever it is connected as the errror is reported in the switch interface to whatever is directly connected with this interface check the cabling between that and switch.

Regards,

Ankur

182
Views
9
Helpful
4
Replies