02-17-2006 03:59 PM - edited 03-03-2019 01:53 AM
hi, im trying to configure my 871 router, in the online manual (http://www.cisco.com/en/US/products/hw/routers/ps380/products_configuration_guide_chapter09186a008045d249.html#wp1137813) it says: Router# show running-config but how can I connect to the terminal port in order to telnet the cisco?
I plugged a rj45 cable between the port and my nic's pc... and it has no connecivity... or must I use a dummie terminal or some like that in order to get connected to the shell terminal?
thanks in advance.
02-17-2006 04:53 PM
It should have came with console cable. You need to console into the device.
02-17-2006 09:47 PM
Hi,
If you need to make a console cable, follow the cabling pinout requirements in the following document:
Hope that helps - pls rate the post if it does.
Paresh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: