The 8A/S card for 2600/3600 support max speed 128Kbps at sync. according to cisco documents, but when I use NetIQ's QCheck to test the network throughput on a point-to point connection between two 8A/S card, it shows a throughput of 240Kbps~245kbps when using TCP,and 30Kbps~40Kbps when using UDP. I am very confused now.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...