Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

a strange problem

I have two cisco2948g-l3,here I marked as A and B.And they are all worked after configured.

Now,I found that switch A's Command Line appeared bad characters by console.But Switch B is Ok.I do nothing to my PC.(9600,8....)

As I use another PC,two switch are OK.

  • Other Network Infrastructure Subjects
1 REPLY
New Member

Re: a strange problem

There definitely appears to be something going on, particularly if you can use a different PC and everything's ok. Double check the settings under LINE CON 0 to make sure that they are indeed the 9600-8-N-1 you think they are, or you want them to be.

104
Views
0
Helpful
1
Replies
This widget could not be displayed.