Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

About atm configuration

We have one Central site and many remote site.

Central site is ATM-A3-OC3SMI and remote site is ATM-e1.

Our diagram is

Central Router

l (Atm-60M)

l

ISP ATM

l....l

l l

Remote site(e1)

We configured Remote site with ( cbr 1920), and

Center atm 0.1 point to point

pvc 10/31

cbr 1920

test resut is about 20Kbps, so we change center with

UBR 1920, reset was 180Kbps.

1.Why when we use cbr, rate is very low than UBR?

2.When using UBR, both side(Center and Remote) must have smae UBR?

or,Center(UBR),Remote site(CBR) this configuratin is

possible?

anyway, we are using UBR(Center), CBR(Remote) .

1 REPLY
Bronze
91
Views
0
Helpful
1
Replies
CreatePlease login to create content