05-13-2003 08:33 PM - edited 03-02-2019 07:19 AM
Hi, all...
I have a question. I just replaced a network device from Cisco 3500 router to Catalyst 4506. and the ios version of cat 4506 is 12.1.13 EW.
I only need the function of Bridge-group to enable Bridge mode.
But I cannot find anything about that configuration on cat 4506
How can I enable the bridge-group ?
Any answer welcome......
Thanks in advance.....
05-14-2003 12:00 AM
Fallback bridging is not supported in 12.1(13)EW or in any other software for the Sup3/Sup4. (Look up unsupported features in the release notes).
So if you want to bridge between VLANs, you'll need an external router to do so.
-A
05-14-2003 02:33 AM
Thanks , ahoejmark
I will do that......
Best Regards....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: