so if the packet is sourced from 10.3.3.2,it will be routed out interface serial 2 and serial 3 .but if there is no route for the packet's destination network in the routing table,should the packet still be routed out interface serial 2 and serial 3?
And if there are two routes for the destination network,how can they choose the route?Does these two interface routed in a load balance fashion?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...