cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
512
Views
0
Helpful
2
Replies

About SNMP Cold Start....

t.sawamura
Level 1
Level 1

Cisco7206VXR(NPE-200,NPE-300),Cisco7206(NPE-200)

Version down 12.1.14 ¨ 12.0.5T1

The above-mentioned Router was downed in the version.

At reload, Cold Start@does not come out.

Does not an error alone come out why?

iDoes the WarmStart@message come out?j

2 Replies 2

thomas.chen
Level 6
Level 6

If I am not wrong, you want to know why the cold start messages don't pop up, when there is cold start.This seems to be a bug in the IOS version you are using . A similar bug, CSCdt89506 has been observed earlier. For more details on it, you can check out on the bug tool kit available on the CCO. This bug is caused due to the mis-configurations in one of the snmp commands given below.

snmp-server host 10.1.1.1 string snmp

Thank you.

I will try.

snmp-server host xx.xx.xx.xx string snmp @©

Nice one! Nice one!

Your Good Job!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: