Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

about statci nat , Visits a WEB-server in lan .

I have a router ,configured static nat:

ip nat inside souce static 192.168.0.2 202.11.22.22

The 192.168.0.2 is a Web-server

The PC in same lan ,Visits Web server use IE with ip address 192.168.0.2,but no advantage.sho want to use Domain name

Visit Web-server .like :www.webserver.com.

how can i to configure on router?

1 REPLY
Bronze

Re: about statci nat , Visits a WEB-server in lan .

According to your static NAT configuration , you have created a static mapping for the IP address of the Web Server.But,if your requirement can be more precise, then it will help a lot to find u the best answer. If your requirement is to statically map this web server's private IP address 192.168.0.2 to the Real IP address ,then it means that this web server is trying to a public IP address.Also ip nat inside source static command is alone not enough to configure the static NAT.

ip nat inside/outside intf config cmd is also required to configure this static NAT.ip nat inside cmd is used at the inside interface(interface whose ip address is 192.168.0.2) and ip nat outside cmd is used at the outside interface(intf whose ip address is a real one)

226
Views
0
Helpful
1
Replies
CreatePlease to create content