About the features of Catalyst 4500 SUP-II+Plus-TS supervisor engine

[boyyyjames]

Could anybody tell me if the SUP-II+Plus-TS can support PBR(policy based routing)?

[abhishek_nandavat]

Hi,

Yes it does support PBR. Have a look at its datasheet:

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_data_sheet09186a0080197424.html

Hope this helps.

Regards,

AbhisheK

Please rate all posts!!!

[boyyyjames]

Thank you so much.

But I find it in the table2, at least supII+plus doesn't support PBR.

I want to know if supII+plus-TS does?

Thanks,

james

[abhishek_nandavat]

Hi!

I apologise for saying that it does support PBR, actually I had sup-IV goin on in my mind!

Well you can have a look at the following data-sheet, that should help!

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_data_sheet0900aecd8017a0c5.html

Regards,

AbhisheK

Please rate all posts!!!

[boyyyjames]

It is helpful. Appreciate your help.

Both of below images are IP base edition. So it will not support PBR and other dynamic route protocol except rip.

S45IPB-12231SG Cisco IOS Software for the Cisco Catalyst 4500 Series (IP Base image with EIGRP-stub support)

S45IPBK9-12231SG Cisco IOS Software for the Cisco Catalyst 4500 Series (IP Base image with Triple Data Encryption Standard [3DES] and EIGRP-stub support)