04-26-2006 02:28 AM - edited 03-03-2019 02:57 AM
how can i creat an access list to permit only one ip to access my specific subnet, e.g
IP = 192.168.5.x
subnet Address = 255.255.255.128
only specific IP can telnet to the above subnet.
and i am also very thankfull if any one send me a link about access-list tutorial.
Thank You.
04-26-2006 02:38 AM
Assuming that you apply this ACL in an outbound direction on the interface that you are restricing access to, it would be something like this:
interface Ethernet0
ip access-group 10 out
!
access-list 10 permit host 192.168.5.1
With the above setup, only 192.168.5.1 will be able to access the LAN segment connected to Ethernet0.
Here's a link explaining ACLs:
Hope that helps - pls do remember to rate posts that help.
Paresh
04-26-2006 02:50 AM
ok thanks,
But when i access, to this web side, it ask to me for a CCO username and password,
2nd think, i would like to implement access-list on a layer 3 switch, which dont allow to access particular (IP's subnet), only single IP can access to this subnnet IPS.
04-26-2006 03:04 AM
Try this link instead:
http://www.cisco.com/en/US/products/sw/secursw/ps1018/products_tech_note09186a00800a5b9a.shtml
The config is the same even if it's on a layer 3 switch.
I would appreciate you rating the posts if they help.
Paresh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide