Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

access list

i want to add the following two lines to my access list 1, can u tell me the commands

access-list 1 permit 10.4.1.0 0.0.0.255

access-list 1 permit 10.10.0.0 0.0.255.255

2 REPLIES
VIP Purple

Re: access list

Hello,

not 100% sure what your question is, but cut & paste the existing access list 1 to a text editor (e.g. Wordpad), and add the two lines you have posted.

Remove the existing access list from the interface with the ´no ip access-group 1 in/out´ command, then remove the access list in global configuration mode from the router with the ´no access-list 1´ command. Then, in global configuration mode, paste the modified access list into the router config and apply it to the interface, in interface configuration mode with the ´ip access-group 1 in/out´ command.

HTH,

Georg

New Member

Re: access list

standard ip access-list 1

permit 10.4.1.0, wildcard bits 0.0.0.255

permit 10.13.1.0, wildcard bits 0.0.255.255

i want to add that list

thanks

89
Views
0
Helpful
2
Replies