cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
430
Views
0
Helpful
3
Replies

Access Server icmp problem

drigoldi
Level 1
Level 1

Hello,

I recently installed a 16AM on a 2610 router.

I configured the async 33 interface to accept incoming call everything is ok but after connected (using my laptop modem) I can't ping outside the Ethernet inteface.

I enabled routing and directed-broadcast on the eth and async33 interface ... but no way to make it ping the internal lan interface.

What should be the "state-of-the-art" configuration to dial-in into a LAN ??

Thanks in advance

Regards

Dan

1 Accepted Solution

Accepted Solutions

nihanth
Level 1
Level 1

async configuration...

line 1

modem autoconfigure discovery

modem inout

transport input all

login local

autoselect ppp

int async 1

ip unnumbered e 0

enc ppp

async mode interactive

peer default ip address xxx.xxx.xxx.xxx

If your laptop has got ip address which is from your ethernet lan, you are not able to ping your ethernet ip address that might be some problem.

View solution in original post

3 Replies 3

nihanth
Level 1
Level 1

async configuration...

line 1

modem autoconfigure discovery

modem inout

transport input all

login local

autoselect ppp

int async 1

ip unnumbered e 0

enc ppp

async mode interactive

peer default ip address xxx.xxx.xxx.xxx

If your laptop has got ip address which is from your ethernet lan, you are not able to ping your ethernet ip address that might be some problem.

I have the same problem but instead a Ethernet interface I have a Token Ring Interface, so you still having the problem? How you resolve it? I´m with the same problem but I don´t know how to solve it!

The problem was in the static routing table.

I had to include all interface's networks manually.

Regards

Dan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: