I have a 3640 access router with a PRI-ISDN interface. It works as an access server using free tacacs as an AAA server. I need to use this interface, without disturbing access service, for dialing out (with IPCP address negotiation from remote side and NAT).
Does have anybody experience with this or a sample config ?
I have seen this already, but in this example for each incoming caller must have a separate dialer interface with dialer remote name. That is what I should avoid. I would like to use tacacs to store dial-in users.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.