Access to Terminal Server

[bschultheis]

I'd like to setup a 2600 as a terminal server for console access to routers and switches at some of our sites. If possible, I'd like more than one person to have access to the terminal server at one time. It seemed that the WIC-2AM (Integrated V.90) may allow 2 simultaneous calls - could I use that WIC as the remote access port to the 2600 terminal server.? And just to be sure, could you also provide me with the Cisco recommended configuration build for the above mentioned terminal server (including recommended IOS)

Thanks and Best Regards

[makchitale]

Yes, we can use the WIC-2AM on the 2600 for dialin access. On the 2600 platform the WIC-1AM & 2AM are supported on IOS 12.2(2)XB, 12.2(8)T and later.

The configuration will be similar to one in the below URL,

http://www.cisco.com/warp/public/471/nm-xam_dialin.html

http://www.cisco.com/warp/public/793/access_dial/comm_server.html

Thanks, Mak.

[ndoshi]

http://www.cisco.com/warp/public/793/access_dial/comm_server.html

Above url explains how to configure 2600 as a terminal server .

You can use wic-2am to get remote access , Also you can use AUX port

with external modem for dial in .

Use latest IOS depending on memory and flash available on the router .

Nilesh