My requirment is say if remote office is using 10.x.x.x network and HO at remote end is using 10.x.x.x network.Everthing is properly routed so that now remote office is able to work with HO.Now remote office LAN is entirely changing to 192.168.x.x network.Now what all changes has to be done on the remote network router as well as HO Router?? Any changes has to be done in the intermediate WAN ? How will this 192.168.x.x will acess HO's 10.x.x.x ? Please clarify me.. any way to access...
It depends on if the 10.x.x.x networks are subnetted and you are running routing protocols.
Typically all you need is a static route at each end pointing to the other network through the wan link. That way each router knows how to reach the other network. If the address on the remote routers wan link is 18.104.22.168 then the HO router would say
ip route 192.168.0.0 255.255.0.0 22.214.171.124
the mask may be different depending on what mask you use in the 192.168. network.
The remote would have
ip route 10.0.0.0 255.0.0.0 126.96.36.199 if the serial address on the HO router is 188.8.131.52. Again the mask on the 10. network needs to be set according to what you are using.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...