Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Accessing the central site with Windows 9x

Hello all,

Can anyone recommend references for accessing a central site using Windows 9x?

Thanks!

4 REPLIES
Cisco Employee

Re: Accessing the central site with Windows 9x

You need to give us more information about what kind of router you have at central site..Is it configured or not?? ..Tejal

New Member

Re: Accessing the central site with Windows 9x

Thanks for responding ... my question was more general b/c I'm looking for a general response. But, for a specific example, let's take an unconfigured 3640 router. I'm really just looking for some general references about accessing central sites using Windows 9x. Any help is appreciated. Thanks!

Silver

Re: Accessing the central site with Windows 9x

Again depends on the following the hardware will change:

-Number of users needing simultaneous access to the central site, that is, number of modem required.

-Whether we have a CAS T1/PRI / BRI or POTS line comming in from telco.

The below URLs has sample configs that should be helpful.

http://www.cisco.com/warp/public/471/bri_3640.html

http://www.cisco.com/warp/public/471

Thanks, Mak.

Cisco Employee

Re: Accessing the central site with Windows 9x

Adding one more sample config for T1/E1 line at 3600 side..

http://www.cisco.com/warp/public/793/access_dial/t1_dialin_5412.html

88
Views
0
Helpful
4
Replies