Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

acl and multicast problem

Is there any limitations for ACL and multicast on 6509?

I created this acl:

permit ip any host 239.2.2.2

aplied it to a vlan interface for in and out, but when I use sh access-l command the math count shows only the number igmp reports from a host to the router, but not the total amount of multicast traffic. Why?

1 REPLY
Silver

Re: acl and multicast problem

According to the cat 6500 Series Cisco IOS 12.2SX, there is a separate section for configuring VACLs(VLAN ACLa) with relevance to multicast packets.I think this URL will provide u an answer for your question.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080160a7e.html#wp1039268

328
Views
0
Helpful
1
Replies