I am running ACLM 1.3 as part of CiscoWorks2000 on Win2k. When I launch ACL Manager for my 3620 routers it works fine. Doing the same for the 7507 and 7513 routers opens the java window but clicking on the device gives "Device Not Supported" and I can't see any acl info. The documentation states that these routers are supported. Any clues what to check?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...