I am using acs 3.0 for authentication for the dial-up users. Now I configured the users for the specific hours and specific session of the day to limit the user usage quotas. Now if the user is exceed the usags quata, it's account is showing disable in ACS, but user can still able to work till he is not disconnecting. Now I wan't to make a setting so if the user is exceed his usage quotas then he should disconnect same time. Please help me to configure this.
For a user who has exceeded his quota, Cisco Secure ACS denies him access upon his next attempt to start a session. If a quota is exceeded during a session, Cisco Secure ACS allows the session to continue. So it's not possible to configure it the way you described
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...