Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Acting as a DHCP client...

Is there any known way to configure a cisco 2620 router to pick up a DHCP assigned address on a FE port? I'm looking to NAT traffic from an DHCP assigned IP to a private LAN, using the access lists to control access.

Any known solution with what I have? Currently using a stock Cisco 2620 router with a single port F/E module and 16MB FLASH.

1 REPLY
Cisco Employee

Re: Acting as a DHCP client...

You mean like this:

int FastEthernet0

   ip address dhcp

ip nat inside source list 100 interface FsatEthernet0 overload

139
Views
0
Helpful
1
Replies
CreatePlease to create content