05-19-2003 04:38 AM - edited 03-02-2019 07:26 AM
How does one change the activation character for the cisco 2950. I know iot can be done on Cisco routers with activation character command.
Any ideas
05-19-2003 03:47 PM
What do you mean by activation character? Can you elaborate on what exactly you are looking for?
05-20-2003 09:00 AM
On cisco switches and routers one you configure the hyper terminal, one has to press ENTER key to get the display. On cisco routers one can change this by entering "activation chracter
Hence to see output on the screen when hyper terminal is connected, one has to press the key corresponding to the respective ASCII character.
I know how to do on the routers but I would like to know if it is possible on the catalyst and if so how.
Thanks
Agnelo
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: