Re: Active SUP in Cat6500 giving Centauri Interrupt L3 parity er
PFC contains the MLS short cuts programmed for hardware forwarding. So these indicated that software has detected parity error while reading/writing the flows. Depending on how much memory section has gone bad, you may/may not see any effect. Now if you are seeing this message on the redundant supervisor as If HA is enabled, the second PFC is also programmed but not used for forwarding of traffic. So it may not any impact for the forwarding.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.