Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Add VLAN in Switch 2950

We have a Switch 2950,I have set VLAN 100 with port 22 and 23, NOW I have add one port in this VLAN 100 group. please advice.

9 REPLIES

Re: Add VLAN in Switch 2950

Hi Jackie

Whats your exact query here ??

regds

Re: Add VLAN in Switch 2950

Dont understand your question. You want to add another port to the VLAN or is it something else???

Please clarify.

Regards,

AbhisheK

New Member

Re: Add VLAN in Switch 2950

Yes, I want add one more port to VLAN group.

Thanks

Jackie Wong

Re: Add VLAN in Switch 2950

enter following command

config)#int fastethernet XX

config-if)#switchport access vlan XXX

config-if)#end

rate this post if it helps

regards

Devang

Re: Add VLAN in Switch 2950

to put your port in vlan 100 use

config-if)#switchport access vlan 100

regards

Devang

New Member

Re: Add VLAN in Switch 2950

Hi Jackie,

Use the following command to add a port in a VLAN

#interfacfe int mod/num

#switchport mode access

#switchport mode access valn vlan-num

#exit

-Senthil Kumar.C

New Member

Re: Add VLAN in Switch 2950

When I following your commend, it show this error

User Access Verification

Password:

CSSWMAR51>enable

Password:

CSSWMAR51#interfacfe int 0/24

^

% Invalid input detected at '^' marker.

CSSWMAR51#

Thanks

Jackie Wong

Re: Add VLAN in Switch 2950

Hi Jackie,

You are on a wrong mode. You have to go to config mode first to go to interface config mode.

So try this

CSSWMAR51#config t

CSSWMAR51(config)#interface fa0/24

CSSWMAR51(config-if)#switchport mode access

CSSWMAR51(config-if)#switchport access vlan

HTH, if yes please rate the post.

Ankur

New Member

Re: Add VLAN in Switch 2950

As per question , if you want to add only single port in vlan 100, you need to do

interface port 24

switch port access vlan 100

no shut

you can check , by command " show switchport brief" , it will show member of vlan 100"

i beliave this will help you .

338
Views
0
Helpful
9
Replies
CreatePlease login to create content