Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Adding a ATM 1A-E3 Module and configurig

I have just installed the above module into a 3640. I have uploaded IOS 12.2 but i am unable to us the controller command to add the atm controller. What command do i need to use to add the controller?

2 REPLIES
Bronze

Re: Adding a ATM 1A-E3 Module and configurig

If you are using the NM-1A-E3 module, then the interface will show up as interface atm x/y, not as a controller. Also, make sure the IOS feature set is PLUS to recognize the NM

Cisco Employee

Re: Adding a ATM 1A-E3 Module and configurig

With that module, you do not have to configure a controller. You should configure the ATM interface directly. Here is a link showing a sample configuration for PVCs:

http://www.cisco.com/warp/customer/121/routed_LLC.html

Also, make sure you have an IOS including the PLUS feature set. In other words, the filename should contain a 's' such as: c3640-is-mz.122-10a.bin

114
Views
0
Helpful
2
Replies
CreatePlease login to create content