Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Adding a new module to a Cat6509

I want to add a new module to the CatOS. This is a Live Catalyst. Please can you tell me how to go about it.

Also can I do it live as in I do not have to power down the Switch to add in this new blade.

Is there documentation as to how to do this?

Thanks for your help

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Adding a new module to a Cat6509

You should be able to insert the module while the system is up and running. You may want to consider doing it during non-peak hours if possible just in case you run into a problem. Otherwise just slide it into an empty slot and configure as needed.

See this site for addtional info.

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_module_installation_guide09186a00801df72a.html#wp42550

Hope this helps.

Steve

2 REPLIES
Silver

Re: Adding a new module to a Cat6509

You should be able to insert the module while the system is up and running. You may want to consider doing it during non-peak hours if possible just in case you run into a problem. Otherwise just slide it into an empty slot and configure as needed.

See this site for addtional info.

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_module_installation_guide09186a00801df72a.html#wp42550

Hope this helps.

Steve

Community Member

Re: Adding a new module to a Cat6509

Thank you very much

95
Views
0
Helpful
2
Replies
CreatePlease to create content