Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Adding a static route

I am new to Cisco command line, so please excuse the basic question. I am working with a Cisco 2620 w/ IOS 12.1. I want to configure a static (default) route. I have tried doing so using the IP Route command, but when I do a SHOW IP ROUTE, it does not display my newly created route. What am I doing wrong?

Please help.

2 REPLIES
Bronze

Re: Adding a static route

Is the route actually accessable, ie can you ping the next hop. If not, it will not be put in the route table.

New Member

Re: Adding a static route

No, the route is not accessible. I am bench configuring the router and then sending to be hooked up at a remote location.

Is there anyway to confirm that the route will show up once the T1 is connected?

320
Views
0
Helpful
2
Replies
CreatePlease to create content