Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Adding New Catalyst

I have an existing Cat3550-48EMI and I want to add to it a Cat 2950SX.

Is there anything special i have to do. They both have a GBIC Inerface so I will conect them using the SC interface on the Cat 3550 to the MTRJ on the Cat 2950.

Is there any other configuration I need to do as I want to start adding devices to the 2950.

Giving VLAN 1 an ip address on the Cat2950, will it be seen by the network?

Thanks

2 REPLIES
Bronze

Re: Adding New Catalyst

You are planning to trunk between switches I guess. Check the below link for more understanding

Understanding and Configuring VLAN Trunk Protocol (VTP)

http://www.cisco.com/warp/public/473/21.html

New Member

Re: Adding New Catalyst

You'll want to set up a trunk and VTP. I think the 2950 only allows 802.1Q trunking so you'll go with that on the 2550

854
Views
0
Helpful
2
Replies
CreatePlease login to create content