Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ADSL vitrual templete

we have an ADSL service connecting into 2600 Router, the ADSL customers connecting through vpdn, so we have a Virtual-Template interface that contain the configuration of this ADSL service .

and when each user connect to the router its virtual access interface goes up.

i want to make a traffic shape into the virtual access itself

and all customers are shared the same BW, and i only can make the traffic share into the all users.(into the serial connection).

i want to make a traffic shape into the virtual access itself

,how can i do that??i want the access rate is to be valid per user-network interface(per virtual access interface)

1 REPLY

Re: ADSL vitrual templete

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

98
Views
0
Helpful
1
Replies