Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

AGFA C3548 Collisions

We have 2 AGFA Equipment connections that run Unix Dos system. They want to connect 100/Half and no matter how I set the port on the C3548 switch I have 27-35% collisions. No help from the Manuf. Is there any adjustments I can make to lower the collision rate?

1 REPLY
Community Member

Re: AGFA C3548 Collisions

I have run into the same problem w/ AGFA. As far as I know there is no solution to this as hald duplex will have collisions by nature. AGFA has to start making HW that will work at Full duplex

70
Views
0
Helpful
1
Replies
CreatePlease to create content