I need to connect Site A (HQ) to Site B (DataCenter). Bandwidth requirements are 6Mbps. Sites A and B are across the street from each other. What is the best way to load balance 4 point-to-point t1 leased lines between 2 3640s. CEF? If so, could anyone provide a sample config?
I would put the 4 T1 leased lines in a ppp multilink bundle. To configure this, put the following commands on each interface you want to have in the multilink bundle:
By the way, as far as I know, CEF defines the fastest method by which a Cisco router forwards packets from ingress to egress interfaces, so it only applies to switching packets within the router, not between routers.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...