I would understand which is the trick (if exists) to aggregate a couple of these interface to see both a single interface. I have been told that provider assigns only one PVC but how can I split it (from config point of view) between two physical interfaces.
I thought to use PPP multilink group interface but it allows me to configure only DXI protocol.
Re: Aggregating more g.shdsl interface on Cisco 26xx
Well thanks for the white paper. However the ISP provide me only one PVC id (8/35). But sincereley I don't know how to split it. So do I need to configure it twice on two subinterface and then aggregate them using these methods ?
This is a very strange trick because it's probably easier to aggregate two different PVCs (and for it I thank you for the doc) instead of split one.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.