Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Aggregation of 100LX - 2955

Hi,

I would like to know what type of aggregation of 100LX that is available. Do I have to use a 4000 chassi with a WS-X4148-FE-LX-MT= card or a 6000 chassi with a WS-X6148-FE-SFP to aggregate 100LX ?

I have today a ring topology of 2955S switches on 100LX, but would like to change to a star topology. Is there any chance that the GLC-FE-100LX SFP will be supported in a 3560 or 3750 switch ?

(ref. http://www.cisco.com/en/US/products/hw/modules/ps5455/products_device_support_table09186a0080380847.html )

regards rolf

2 REPLIES
Silver

Re: Aggregation of 100LX - 2955

think you can use a catalyst 6500 series switches for aggregation, check the following link for more information :

http://www.cisco.com/en/US/products/hw/switches/ps708/products_data_sheet0900aecd801c5cce.html

yes, the GLC-FE-100LX SFP will be supported in a 3560 or 3750 switch, you can check from the "Table 2 100-Megabit Ethernet SFP Module Platform Support and Minimum Software Release Requirements" in link you have specified :

http://www.cisco.com/en/US/products/hw/modules/ps5455/products_device_support_table09186a0080380847.html

New Member

Re: Aggregation of 100LX - 2955

Hi,

I was not able to read out of the table that there is support for GLC-FE-100LX as it is not mentioned in the transceiver colounm. I see however that the new 2960 models have support for this SFP. I therefore wonder if there is any physical/electrical limitation that govern that it can not be used on 3560/3750?

regards rolf

123
Views
0
Helpful
2
Replies
CreatePlease login to create content