Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Alcatel HDSL Line Runner connection with IGX UFM-C cards

We face problems when our transmission department uses some specific Alcatel modems to offer 1 Mbps Frame Relay service.

The Alcatel HDSL Line Runner equipment is used to provide Frame

Relay access at nx64kbps (n=16 - 32). The problem is that when configuring

this equipment (NTU and line card) to operate at 1024kbps - 1984kbps, time

slot 16 is not used (e.g. for 1024kbps time slots 1-15 and 17 are used).

This is done in accordance with ITU standards G.703/G.704.

The question is if anyone has installed this device (Alcatel HDSL Line Runner) and if there are some special configuration aspects regarding the UFM-C card side in order to cooperate.

1 REPLY
Bronze

Re: Alcatel HDSL Line Runner connection with IGX UFM-C cards

I think you can refer this link for for configuring frame - relay. May be you are missing some parameters. Also check for the version of software and the hardware you are using.

Displaying and Configuring UFM-C Cards

http://www.cisco.com/univercd/cc/td/doc/product/wanbu/svplus/cwm_92/cv84r2/ufmc.htm

Card Installation and Node Startup

http://www.cisco.com/univercd/cc/td/doc/product/wanbu/igx8400/8_2_0/ic82/igxich3.htm#xtocid323819

675
Views
0
Helpful
1
Replies
CreatePlease to create content