I don't think there is any show command that displays all the members. You can however use the 'ping' command with the group address to know who are the members in the whole network, based on the responses received . If you are very particular about the members directly connected to a device, you can use the extended 'ping' command from that device and set the TTL to 1. This will ensure that only the directly connected receivers of the group respond to the 'ping' request.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...