allowing telnet inside a policy mapped port

[john.graves]

if I configure an access list to route all packets to a specific port ie

access-list 120 permit ip any any

route-map OUT-IN permit 20

match ip address 120

set ip next-hop eth0/0

what entry will allow me to telnet into the router through the interface that has this policy applied to it?

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.